3D printing
After thinking about it for much too long, http://vhealthportal.com, finally I decided to get myself a 3D printer! I ordered this one: http://www.aliexpress.com/snapshot/7363019256.html?orderId=73126328946861 from AliExpress, it was shipped to me in 5 days. Here’s the assembly video:
And a few prints:
Tor Poznan – Track Day
Took my car to a Track Day on a local track. This is a footage from a training session on a karting section. The next morning, after an hour on the big track my turbocharger went bust.
DIY project – turn a disk brake and gearbox parts into a desk lamp
This is a desk lamp I created from an old BMW rear brake disk and thrashed internals of a WSK motorcycle. I was lucky the gear shaft had a hole going through, so I could thread in the wires inside and get a really neat look. I just had to chop one end off and weld on a big ol’ nut. Then I hollowed out a corresponding bolt to use as a threaded end. I finished it with a brass like fitting with a pull string switch and a retro LED bulb that gives that nice, warm light.
AEE MagiCam S51 action camera test
Testing a new camera. I have to adjust the mounting angle, it’s too low. Also I put a wrong mic plug and got terrible wind noise. I managed to remove it a bit in http://vhealthportal.com/product-category/anti-diabetic/ post processing.